Break the corners off the stone before using POS 1.[See Consolidated Prod # 20041]  The flat side of the stone must be smooth. Saw marks can damage the polishing bits. Use all five positions. Do not skip a step. The ogee router bits have the proper infeed built into them. You should not have to adjust your machine after each position. Just take off one bit and put on the next without adjustment. This is very important because the polishing bits can be easily damaged if the infeed is too great. When polishing, travel across the piece at a stead rate don’t go too slow.

For best results use 4000-10000 RPM for POS1,2 and 3 and 4000-6000 RPM for POS 4 and 5. In any event, do not exceed 10,000 RPM with any of these router bits. Inspect each bit after use. Do not use a bit that has been damaged or has signs of unusual wear. Pos 4 and 5 can be used without a bearing. Best results are obtained if a bearing is used.